公司动态   News
联系我们   Contact
你的位置:首页 > 公司动态 > 技术支持

无锡电动卷帘门电机遇到停止工作或者工作缓慢怎么办?

2018-11-1 7:45:12      点击:

卷帘门电机不动或转速慢: 此故障原因一般是线路断路、电机烧损、停止按钮没复位、限位开关动作、负载较大等引起。

处理方法:检查线路、并接通;更换烧损电机;更换按钮或重复按动几次;检查遥控控制模块.拨动限位开关滑块使它脱离微动开关触点,并调整微动开关位置;检查机械部分有无卡阻,若有则消除卡阻清理障碍物。


电机更换安装:电动卷帘的电机与卷筒芯轴之间是由传动链条来连接,电机地脚用螺钉固定在链轮支架板上。更换电机前,必须将卷帘门降至最低端或用支架将卷帘门撑住。一是卷帘门的制动是靠电机本体上的制动器来起作用,电机拆除后,卷帘门则没有制动而自动下滑;二是可以使传动链条放松,方便将链条取下。

更换电机的步骤:将电机接线做好标记然后拆除,将电机地脚螺丝拧松将传动链条摘下,最后将电机地脚螺丝拆除将电机取出;新电机安装顺序相反,但要注意,电机安装好后,其本体上的环形手拉链条应自然垂直向下,不得有卡阻现象。

Rolling shutter door motor fixed or slow speed: This fault is generally caused by circuit break, motor burnout, stop button not reset, limit switch action, load, etc.

Processing methods: check the circuit, and connect; replace the burned motor; change the button or press repeatedly several times; check the remote control module. Push the limit switch slider to make it out of the micro-switch contact, and adjust the position of the micro-switch; check whether there is a mechanical part of the sticking resistance, if there is, remove the sticking resistance to clear the obstacles.


Motor replacement and installation: electric curtain motor and reel mandrel are connected by transmission chain, motor foot is fixed on the sprocket bracket plate with screws. Before changing the motor, the shutter door must be lowered to the lowest end or the shutter door should be braced with the support. One is that the brake of the rolling shutter door is operated by the brake on the motor body. After the motor is removed, the rolling shutter door slides automatically without braking. The other is that the driving chain can be relaxed and the chain can be easily removed.

The steps of replacing the motor are: marking the connection of the motor and removing it, loosening the anchor screw of the motor to remove the drive chain, and finally removing the anchor screw of the motor to remove the motor; the installation sequence of the new motor is opposite, but it should be noted that after the motor is installed, the ring-shaped hand zipper on the motor body should be naturally vertical downward, not allowed. There is a blockage phenomenon.